BANISH 30 HUB Retrofit Kit

Installing the Retrofit Kit

Installation Instructions

Tools Needed for Instillation

• Vise
• Soft Jaw Adapter or Aluminum Vise Jaws
• 3/8” drive ratchet
• Heavy towel
• Rocksett Muzzle Adhesive
• Industry Hub Adapter
• Custom Hub Adapter Tool

Before removing the BANISH 30 direct thread mount, soak the mount end of the suppressor in warm water for approximately 15 minutes to break down the Rocksett Muzzle Adhesive that was used to secure the mount in place.

Once soaked, use a heavy towel to wrap the suppressor and secure it in a bench mounted vice using the soft jaw adapter or aluminum jaws. WARNING: This process could damage the finish on your suppressor!

Using the 3/8” drive ratchet and the Hub Adapter tool, slide the toothed end of the tool onto the direct thread mount and rotate counterclockwise to remove the mount. Note, the mount is Rocksett in place, so it will take some force to remove.

Once the direct thread mount is removed, use more water to clean the threads on your suppressor and then dry. Next, flip the tool and insert it into the adapter so that the gear shape of the adapter is matched with the gear of the tool.

Apply a small amount of Rocksett to the threads of the adapter and thread the adapter into the suppressor. A small amount of force may be used to torque the adapter to the suppressor.

Allow the Rocksett to dry for 24hrs before using your suppressor.

*Silencer Central and BANISH Suppressors are not liable for any damage to your suppressor that may occur during the removal of the factory-installed direct thread mount or the installation of the HUB Retrofit Kit. This procedure involves the use of tools and adhesives, and improper technique may result in cosmetic or functional damage. Proceed with caution and at your own risk.